Download  Print this page

Whirlpool W10115226B Installation Instructions Manual page 11

27" wide models - u.s.a. only
Hide thumbs

Advertisement

Table of Contents
3.
connect neutral ground wire
and neutral wire
Connect neutral ground wire (E) and place
hooked end (hook facing right) of neutral
wire (white or center wire) (C) of direct
wire cable under center screw of terminal
block (B). Squeeze hooked ends together
and tighten screw.
4.
connect ground wire
A
F
Connect ground wire (green or bare) (F) of direct wire cable
to external ground conductor screw (A). Tighten screw.
5.
connect remaining wires
Place hooked ends of remaining direct wire cable wires
under outer terminal block screws (hooks facing right).
Squeeze hooked ends together and tighten screws. Finally,
reinsert tab of terminal block cover into slot of dryer rear
panel. Secure cover with hold-down screw. Now, go to
"Venting Requirements."
ImPoRTAnT: Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
B
1.
C
E
Direct wire cable must have 5 ft. (1.52 m) of extra length so
dryer may be moved if needed.
Strip 3
insulation back 1" (25 mm). If using 3-wire cable with ground
wire, cut bare wire even with outer covering. Shape wire ends
into hooks.
2.
Remove center terminal block screw (B).
3-wire Direct Wire connection
Prepare your 3-wire cable for
direct connection
/
" (89 mm) of outer covering from end of cable. Strip
1
2
Remove center screw
B
11

Advertisement

Table of Contents
loading

  Related Manuals for Whirlpool W10115226B

This manual is also suitable for:

W10115227b-spMedx700xlMedx700xw