Table of Contents
Advertisement
8.
Rotate outer door
Take outer door and rotate it 180º and set it back down on
inner door. Be certain to keep cardboard spacer centered
between doors. Reattach outer door panel to inner door
panel so handle is on the side where hinges were just
removed. Insert 4 door screws.
9.
Attach door hinges
Reattach door hinges to dryer door so that the larger hole is
at the bottom of the hinge.
10.
Remove door strike
Remove door strike from dryer cabinet and set aside.
W10115226B
W10115227B-SP
© 2011 Whirlpool Corporation
20
All rights reserved
11.
Remove and transfer plugs
Remove the 4 screws that attach 2 plugs on the left side.
Transfer plugs to opposite side using the same 4 screws.
12.
Insert screws in hinge holes on
dryer cabinet
noTE: 2 people maybe needed to reinstall door.
Insert screws into the bottom holes on left side of dryer cabinet.
Tighten screws halfway. Position door so large end of door hinge
slot is over screws. Slide door up so screws are in bottom of
slots. Tighten screws. Insert and tighten top screws in hinges.
13.
Remove door strike plug
Remove door strike plug. Insert the door strike removed in
Step 10 into hole and secure with screw. Insert door strike
plug into original door strike hole and secure with screw.
14.
check door strike alignment
Close door and check that door strike aligns with door catch.
If it is needed, slide door catch left or right within slot to
adjust alignment.
Troubleshooting
See the "Use and Care Guide" or visit our website and
reference "Frequently Asked Questions" to possibly avoid
the cost of a service call.
01/11
Printed in U.S.A.
Advertisement
Table of Contents
