Specifications - Makita JN1601 Instruction Manual

ENGLISH (Original instructions)
1-1. Die
1-2. Die holder
1-3. Lock nut
1-4. Wrench
2-1. Gauge for cutting stainless:
1.2 mm (3/64")
2-2. Gauge for cutting mild steel:
1.6 mm (1/16")
2-3. Notch
3-1. Switch lever
4-1. Die holder
4-2. Die

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
4-3. Bolts
4-4. Hex wrench
5-1. Punch
5-2. Punch holder
5-3. Screw
5-4. Hex wrench
6-1. Punch
6-2. Notch
7-1. Bolts
7-2. Die
7-3. Punch
7-4. Die holder
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Outside edge
Inside edge
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 83 dB (A)
pA
) : 94 dB (A)
WA
2
2
2
2
ENE037-1
Vibration
The vibration
determined according to EN60745:
ENF002-2
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
3
10-1. From the top view
10-2. Cutting at an angle to grooves
10-3. Cutting perpendicular to grooves
10-4. From the side view
10-5. Corrugated or trapezoidal sheet
metal
11-1. From the side view
11-2. Cutting head should be at a right
angle (90 ﾟ) to cutting surface.
12-1. Limit mark
13-1. Brush holder cap
13-2. Screwdriver
JN1601
1.6 mm / 16 ga
1.2 mm / 18 ga
0.8 mm / 22 ga
2.5 mm / 13 ga
50 mm
45 mm
2,200
261 mm
1.6 kg
/II
total value (tri-axial
2
) : 7.0 m/s
h
2
ENG900-1
vector sum)
ENG901-1