Table of Contents
Advertisement
General Information &
Specifications
The Batchmate allows you to mix and agitate
chemical in preparation for loading into your
sprayer. This takes the work out of loading
powders or granules and speeds up your
sprayer fill cycle.
Fitted with a high capacity 3" poly pump and
powerful twin agitation system, the Batchmate
delivers maximum chemical agitation and high
tank fill rates to add speed and efficiency to
sprayer loading tasks.
Know Your Product
Getting to know your product prior to
operation is crucial in the safe and efficient
operation of this equipment. Take the time to
familiarise yourself with all the standard and
optional components fitted to your product,
not only do you need to know where key
components are located on your machine
you need to become competent in the correct
operation of these components prior to
spraying operation.
It is also important to become familiar with
5
common spraying methods and common
spraying terms prior to using this product for
the first time.
Chassis
The chassis is an all steel construction. The
chassis is shot blasted, primed and then
protected by the Goldacres paint process for
excellent chemical resistance and durability.
1517
Tank
All tanks are constructed from UV resistant
polyethylene. Polyethylene tanks have a very
high chemical resistance.
Due to the rotomoulding process, there can be
a variance in the overall dimensions of the tank
which in turn results in variations to the tank
capacity. For this reason, calibration markings
should be used as a guide only.
Filtration
Filtration is a critical part of the unit's
performance.
A suction filter between the tank and the pump
handles filtration. It is important that the filter is
cleaned out regularly.
Pump
The pump is critical to Batchmate
performance. Correct operation and
maintenance of the pump will ensure the unit
is able to perform to its capabilities.
Always flush pump with clean water after every
use. Prolonged chemical contact can severely
damage valves, diaphragms and seals.
Do not leave water in pump if unit is to be left
in a cold environment. The water may freeze
and cause damage to pump. Empty pump of
all water and cover the pump to ensure this
situation does not arise. If this has not been
done, and there is a possibility there may be
frozen water in the pump, wait until any ice has
thawed before using the pump.
Machine limitations
All Goldacres equipment is subject to
operating limitations, it is the operator's
responsibility to ensure that this equipment
is being operated within these limitations and
appropriately to the operating conditions at
hand.
Paint Colours
4
Steel work: G13 Dark Green
Identification
When ordering parts or requesting service
information for your product, it is important
to quote the serial number and the purchase
date to assist with receiving the most accurate
information. The location of the stamped ID
plate is shown below.
10
3
2
Advertisement
Table of Contents
