Send One Sequence To Keystep 37 - Arturia KEYSTEP 37 User Manual

9.4.3. Send one sequence to KeyStep 37

9.4.3.1. When synced

Important: The following process will send a single sequence to KeyStep 37 and will overwrite the
sequence in the target memory location.
There are two ways to send a single sequence to the KeyStep 37 when it is synced to the
MIDI Control Center.
First use the +/- buttons in the Project Browser to open the Template and locate the sequence
you want to send. Then you can do one of two things:
• drag the sequence on the Working Project. It will be sent into the KeyStep 37 at
the same sequence location as the source sequence (i.e., #1 will go to #1)
• drag the selected sequence to one of the eight tabs in the Seq Editor window.
That way you can specify exactly which sequence location in the KeyStep 37 will
receive the sequence. See
9.4.3.2. When not synced

Important: The following process will send a single sequence to KeyStep 37 and will overwrite the
sequence in that memory location.
If you'd like to transfer only one sequence from a Template to the KeyStep 37, find that
sequence in the Project Browser and drop it onto the Working Project. This will send the
selected sequence directly into the KeyStep 37 at that same sequence location.
In the example below, Sequence #1 from the Berlin 1 Template will overwrite Sequence #1 in
the KeyStep 37 internal memory.
85
section 8.9 for more information.
Arturia - User Manual KeyStep 37 - The MIDI Control Center