Arturia KEYSTEP 37 User Manual page 114

9.10.4.2. MIDI Note reference (0V, 1V)
KeyStep 37 provides the option to set a separate reference note for both Volt per Octave and
Hertz per Volt formats. This parameter will change from a 0V reference to a 1V reference
depending on which Pitch CV Output option is selected.
Volts per octave uses a 0V MIDI note reference
Hertz per Volt uses a 1V MIDI note reference
9.10.4.3. Note Priority
Since CV connectors are always monophonic, it's important to be able to determine which
note from a polyphonic sequencer track or keyboard will be interpreted as the one the mono
synth on the other end should play.
And even some mono synths prefer one or the other of the three choices KeyStep 37 gives
you: Low note priority, High note priority, or Last note priority.
9.10.4.4. Mod CV source
This parameter determines which KeyStep 37 feature will send signals to the Mod CV output:
the Mod strip, velocity or aftertouch.
9.10.4.5. Mod CV max voltage
Each of the three sources has a '˜zero' point that translates into 0 Volts. This parameter lets
you specify whether the range will be 0-5V, 0-6V, etc., on up to 0-12V.
9.10.4.6. Pitch Bend Range
This parameter sets the maximum about the Pitch CV output will vary when the Pitch strip
is used.
109 Arturia - User Manual KeyStep 37 - The MIDI Control Center