Spectrum Oxford Series Assembly Instructions Manual

Logo/Company Name
4"w x .75"h
Assembly Instructions
7
4
2
8
CASTERS/GLIDES
CASTERS/GLIDES
8
6
1
In/Out and Up/Down back adjustments not available on all options.
1) Remove base, back/back bar, pneumatic
cylinder, casters/glides, and seat from box.
2) Put casters or glides on base. Use pressure to
push in (8).
3) Slide optional foot ring (4) over pneumatic
cylinder from bottom (2) about halfway up
5
the cylinder and tighten knob (7).
4) Place base with legs on hard level surface (1).
5) Insert pneumatic cylinder as shown in (2)
into center hole of base and lightly push
down. Adjust foot ring to desired height.
6) Turn seat upside down to assemble back. It
may be helpful to lay the seat on the edge of
a table to slide the back bar into position.
3
7) Loosen knob (6) counter clockwise slightly
to allow the back bar to slide into the control
mechanism on the seat. Push in until you
hear it click. Then tighten by turning knob (6)
clockwise, do not overtighten.
8) Turn seat and back over and align the center
hole on the bottom of the seat with the top
of the pneumatic cylinder and lightly push
down. With the weight of your body, carefully
sit on the seat. This will press the base,
pneumatic cylinder, and seat together.
9) To raise the height of your chair simply pull
up on lever (5) while not seated.
10) To lower the height of your chair, while
seated on chair, pull up on lever (5).
CSO-05