Operation
Operation
This glass ceramic hob is equipped with
electronic sensor controls which react
to finger contact. For safety reasons, in
order to switch the hob on, the On/
Off sensor needs to be touched for a
little longer than the other sensors.
A tone sounds each time a sensor is
touched.
In order to set or alter a power level or a
duration, the cooking zones and the
timer must be "active". To activate a
cooking zone or the timer, touch the
sensor for selecting the relevant cook-
ing zone or the timer. After you have
touched the sensor, the relevant cook-
ing zone or the timer display will start to
flash. The cooking zone or the timer is
"active" whilst the display is flashing
and you can set a power level or a dur-
ation.
Exception: if only one of the cooking
zones is in use, you can alter the power
level without activating the cooking
zone.
28
Malfunction due to dirty and/or
covered sensor controls.
If the sensor controls are dirty or
covered this could cause them to fail
to react, to activate a function or
even to switch the appliance off
automatically (see "Safety features",
"Safety switch-off"). Placing hot
pans on the sensor controls/indicat-
ors can damage the electronic unit
underneath.
Keep the sensor controls and indic-
ators clean.
Do not place anything over the
sensor control or indicators.
Do not place hot pans over the
sensor controls or indicators.