Miele KM 6113 Operating And Installation Instructions page 48

Problem solving guide
Problem
The food in the pan
does not heat up when
the Auto heat-up func-
tion is switched on.
An operating noise can
be heard after the appli-
ance has been switched
off.
The sensors show in-
creased sensitivity or
fail to react.
The hob does not
switch off and  flashes
in the cooking zone dis-
plays.
48
Cause and remedy
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
The cooling fan runs until the hob has cooled down
and then switches off automatically.
The sensitivity level of the sensors has changed.
 Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the hob.
The area surrounding the hob must not be too
dark.
 Make sure that there is nothing covering the
sensors or the hob.
Take any pans off the hob and wipe away any food
deposits.
 Interrupt the power supply to the hob for approx.
1 minute.
 If the problem persists after power has been re-
stored, please contact Miele.
One or more of the sensors are covered, e.g. by fin-
ger contact, food boiling over or an object.
 Remove the obstruction and/or clean the hob.