Table of Contents
Advertisement
13. Drill two %-inch diameter pilot holee in
the top window jamb in line with the partially
plugged holes in the panel frame. Secure
the panel frame to the window jamb wfth two
#8-32 x %-inch self-threading screws. lf
additional holding is necessary, two screws
may be used on the sides of the panel frame
as well.
14. Drill two ecrew4eerance
holee in the
cabinet side channels (near bottom) and two
F&-inch diameter pilot holes in the side
window jambs. Secure the cabinet side
channels to the window jambs wfth two t8-
32 x %-inch self-threading screws. When
doing this, be careful not to twist the side
channel seals with the screws.
NOTE: The insertion of these screws will
prevent the air conditioner from being
pushed into the room.
15. Replete the air conditioner front panel
frame. Make sure to replace the 2 screws
that hold the panel in place. Do not push or
pull on the front panel louvers.
16. Replete the air intnke panel and air filter.
Snap air filter into back of air intake panel
before snapping air intake panel into place.
601
16
Advertisement
Table of Contents
