Table of Contents
Advertisement
6. Place platform aeeembly, with platform tab
against inside of window track, and attach it
to the window jamb. Use appropriate length
screws (item C on page 7).
7. Adjust the platform aeeembfy so that the
outside edge is %-inch lower than the
inside edge. This ensures proper water
drainage from the air conditioner.
8. Level the platform aeeembly from side-
to-side. Also, make sure the window track
is level. Use leveling shims as necessary to
ensure the air conditioner will be level from
side-to-side.
9. Measure the height of the window
opening from the top of the platform
assembly. Subtract 20% inches (the height
of the air conditioner cabinet). Mark this
measurement on the plastic window paneC
along the longer side.
10. Clamp the plaetic window panel between
a board and a work table and cut along the
cutting line with a fine tooth saw. Remove
any burrs with a file.
11. Lift the panel frame from the side channels
of the air conditioner cabinet. Slide the
plastic window panel into the frame with the
smooth side to the outside. Slide the panel
frame assembly back into the side channels
of the air conditioner cabinet. Make sure the
plastic window panel is firmly enclosed on
all sides by the retainer grooves.
Outside odgo
is %-in&
loww nlul
inoido.
+
Put platform
Measure
bebnco
md
subtract
20%
in&se.
10
Advertisement
Table of Contents
