Table of Contents
Advertisement
Installing
in a casement
window
to be fastened to the jamb. If the window cannot
open far enough (more than 15% inches) for the
cabinet to clear the window, remove the window
entirely by drilling out the rivets. Bolts can serve
as the pivots in the future.
NOTE: Open the window the maximum amount
To avoid the crank handle and window clearance
to allow for clearance of the cabinet. The crank
handle should be removed to allow the platform
problems, the unit can be installed in a stationary
sash section. However, the horizontal mullion
and the 2 glass panels must be removed before
installation.
1. Attech support brace to platform as shown.
Use the adjustment bolt and hex flangs nut to
complete the assembly. Choose the slot and
adjustment bolt hole locations that will create a
45' angle between the platform and the
support brace. Try the assembly in the window
to determine if the platform will rest properly
and allow the proper elope (?&inch lower on
outside).
NOTE: lf you are planning to use a skfing-
protection board (see step 5) on the outside of
your house, hold the board in place when
testing the assembly in the window.
2. Drill a Wclnch diameter pikt hole in the
window jamb an equal distance from each side
of the jamb and %-inch up from the window
sill. lf the hole coincides with the window lever
slot in the jamb bottom, an additional hole will
have to be drilled through the platform edge
and the window jamb to miss this slot.
3. Peel off the protective backing from the
track seal and stick the seal to the window sill
on the outside of the bottom jamb.
Equal df~tance from both
l
ickr
Appiytmcksuitotboouteido
dg~ of UM bottom
window jamb.
4.
Screw the pletform assembly to the window
jamb through the pilot hole you drilled in Step
2. Use a #8 x %-inch self-threading screw.
Track seal
-
13
Advertisement
Table of Contents
