Table of Contents
Advertisement
12. Cut l kle channel eeal into 2 equal lengths.
Remove the protective backing and apply it
to the rear side of the cabinet side channels,
starting just below the panel frame assem-
bly. Pinch off excess length so the seal is
even with the bottom of the cabinet side
channel.
Apply w-thor
swl to oich
chne&
juot
beIowodg@of
pad frame.
13. Remove the air intake penel and front
3. Proms down and tilt forward to
Panel frame First, press down on the top
remove front penal fmmo.
edge of the air intake panel and tilt it toward
you. Lit it up to release the bottom spring
clips. Next, remove the 2 Phillips-head
screws holding the front panel frame in
place. Finally, press down on the top edge
of the front panel frame, tilt lt forward, and
lift it up off the bottom spring clips.
NOTE: Do not push or pull on the air
direction louvers.
14. Piece the air conditioner
in the window
opening. It should sit on the platform
assembly so that the window panel frame
and the cabinet side channels are against
the top and side window jambs.
l.Preudown
11
Advertisement
Table of Contents
