Installation - Whirlpool 4380701 Use & Care Manual And Installation Instructions

Installation

short
screws
1.
Insert guide panels into air conditioner guides.
2.
Attach curtains to air conditioner with short screws.
seal strip
3.
Cut adhesive-backed seal strip to window width.
Remove backing from seal strip. Attach seal strip to
bottom of window.
Note: Maintain a firm hold on air conditioner to prevent
it from falling out of the opening during installation.
inner sill
room side
4.
Open window and mark centerline of inner sill.
inner sill
outer sill
8"
(20.3 cm)
8"
(20.3 cm)
OUTSIDE
L bracket
5.
Attach one L bracket 8 inches (20.3 cm) from either
side of centerline, flush against back of inner
window sill, with short side of bracket in vertical
position. Brackets will help hold air conditioner in
place. Use 2 short screws.
screws
centerline
short
INSIDE
screw
centerline
Use two or more people to move and install air
conditioner.
Failure to do so can result in back or other injury.
short
6.
Carefully lift air conditioner and slide it into open
window. Make sure bottom guide of air conditioner
drops into L bracket. Be sure that air conditioner is
centered in window from right to left.
window frame
upper guide
bottom guide
7.
Lower window sash down behind upper guide of air
conditioner. Make sure the air conditioner tilts to the
back as shown.
L bracket
short
screw
wood
screw
8.
Extend guide panels to fill window opening. Use 4
wood screws.
9.
Insert sash seal behind top of lower window sash
and against glass of upper window.
10.
Fasten L bracket using a short screw.
! WARNING
Excessive Weight Hazard
seal
L bracket
about
1/4"
(6.3 mm)
sash seal
11