In.clear - Wellis Olympus User Manual

IN.CLEAR

Bromine based water sanitization system for hot tub
START UP PROCEDURE
(Instruction video: www.geckoal.com/inclear)
1. Fill the hot tub with water.
2. Begin heating the water to your desired temperature.
3. Balance your water parameters (see info in your user guide
regarding water chemistry for hot tub: total hardness,
alkalinity, pH).
4. Start main pump and add BromiCharge™ slowly into the
warm water, 0.54 kg for every 378 liters (1.2 lbs per every
100 gallons) of water.
5. Turn on the in.clear system by pressing and holding the
on/off button for 2 seconds, until your display lights
up. Refer to your user manual for information on achieving
the proper BromiCharge™ quantity.
6. Now you're ready to calibrate your in.clear settings. There
are 2 settings, Maintenance and Boost.
7. Maintenance: Your Maintenance value was set at the
factory. It should read "5" to start. Using your hot tub while
you're establishing the residual will slow the process. Be
patient. Check your bromine level each day with a test kit.
OPTIONAL ACCESSORIES - IN.CLEAR
On/Off Maintenance
Your goal is a residual bromine bank of 3 – 5 ppm. If the
bromine content of your water is less than 3 ppm, press
and hold the Maintenance key
crease the Maintenance setting by 1 or 2 increments with
the up arrow . Repeat daily until your bromine level
stabilizes at 3 – 5 ppm.
IMPORTANT FOR THE STAND ALONE VERSION: Make sure
your hot tub is filtering the water at least 8 hours per day. The
in.clear only creates bromine when the filter pump is running.
8. Boost: Every time you use the hot tub, press Boost
. Boost runs a clean-up cycle that returns your residual
bromine to the proper level. You should run Boost every
time you use the hot tub. Press Boost key
level by using the up and down arrow
number of bathers that use the hot tub (i.e., 2 users = 2,
and so on). With the proper Maintenance level setting,
and consistent use of the Boost mode, your hot tub will be
ideally maintained.
Refer to our web site www.geckoalliance.com/inclear for
detailed information about the operation of the in.clear.
for 2 seconds and in-
. Set the Boost
to select the
83