Maintenance - Wellis Olympus User Manual

FILTER CARTRIDGE REMOVAL AND CLEANING
Cleaning mechanical contaminations via continuous water
circulation and chemical mixture is a basic requirement for
proper cleaning of the hot tub water. Every hot tub has an
engine designed for this purpose. The circulation engine
circulates the water through the filter(s). The filter protects
against contamination floating in the water.
Cleaning of the filter cartridges is recommended weekly.
Soaking the filter cartridges in water mixed with chlorine or
antialgae agents for 24 hours is recommended monthly.
Changing the filter cartridges is necessary every 3 months.
SURFACE MAINTENANCE
Wipe the surface with a wet cloth. Always use a neutral
cleaning product and a soft wiping cloth. Never scratch the
acrylic surface with an abrasive tool, blade, or knife, because
it may cause damage. Never use nail polish remover, acetone,
or paint stripper when cleaning the surface because it may
cause damage.
Maintenace manual for the control panel of the hot tub:
• Do not damage the control panel with anything hard. If
possible,
• Avoid exposing the control panel to direct sunlight.
• When not using the hot tub, always use a hot tub cover.
WINTERIZATION
Remember to correctly maintain the hot tub if you are not
using it in the winter. If you are not using your hot tub during
the winter months and want to put it out of service properly,
call one of our qualified professionals to winterize your hot
tub at a prearranged date and time.
The winterization encompasses the following:
• Drainage of used water
• Cleaning of the inner surface of the hot tub
• Dewatering of pipe and jet system
• Dewatering and disconnecting the engine's interface
• Delivery - reception
If the hot tub is not winterized properly, the system can retain
water that can easily freeze during the winter months. This
can cause heavy irreparable damage to the pipes and the
engine. This will void the warranty.
Maintenance of the out-of-service hot tub:
When you are not using the hot tub, use the thermo cover
and fasten it with the buckles.Do not forget! If the hot tub is
filled with water and you are not using it, lift the cover at least
once a week to ensure proper ventilation. The thermo cover is
multipurpose. Most importantly it decreases the heating time
of the water to operational temperature and decreases the
energy needed to maintain water temperature, decreasing
the operational costs.
Using the cover you can avoid leaves, rain, snow, or other
contamination entering the hot tub water, effectively sealing
it off from environmental effects.
Fastening the cover with buckles prevents young children
from using it without parental supervision.
CLEAN THE FILTER CARTRIDGES WEEKLY AS FOL-
LOWS:
WARNING!
Changing the filter cartridges is recommended every 3 months!
126

MAINTENANCE

Operating the hot tub without a filter cartridge is PROHIBITED
1. Remove the lid of the filter.
2. Take out the filter cartridge.
3. Clean contamination from the cartridge with water.
4. Soak the cartridge in lukewarm water mixed with chlorine
or antialgae agents for 1-2 hours, then rinse it.
Never use an alkaline detergent or a high-pressure cleaner to
clean the filter!
RAINING THE WATER
You can drain the water via the drain outlet in accordance with
environmental standards.
1. Find the drainage and remove the cap.
2. Screw on the metric intermediate piece that came with the
hot tub.
3. Twist the larger receiving part anticlockwise as much as
possible.
4. Pull the receiving part towards you - the water will start
flowing from the hot tub.
5. After the water has drained from the hot tub go through
the previous steps in a reversed order.