Kohler HD Series Service Manual page 44

Disassembly/Inspection and Service
Remove Air Cleaner Assembly
A Vent Hose
Remove Fuel Pump (if equipped)
F
A In-Nipple Fuel Filter
E Tee Fitting
I Outlet Fuel Line
NOTE: Keep fuel lines connected to fuel pump and fuel pump on bracket unless any of these components need to be
replaced.
1. Using Hose Removal Tool (see Tools and Aids), carefully remove vent hose from valve cover fi tting.
2. Squeeze hose clamp and slide it up on fuel line (away from carburetor). Using Hose Removal Tool carefully
remove fuel line from carburetor inlet fi tting. Move clamp (away from tank) and disconnect fuel line from fuel tank.
In-nipple fuel fi lter can stay in tank outlet.
44
A
B
B Clamp
E
B Fuel Pump
F Vent Hose
KohlerEngines.com
1. Loosen knob and remove air cleaner cover.
2. Remove precleaner and paper element.
3. Remove nuts securing air cleaner base to carburetor
studs and screw securing base to crankcase.
4. Using Hose Removal Tool (See Tools and Aids),
carefully remove breather hose from air cleaner
base. (Other end is attached to crankcase.)
5. If engine is equipped with fuel pump, carefully
disconnect clamp securing vent hose to air cleaner
base.
6. Remove air cleaner base and air cleaner base
gasket from studs noting gasket orientation; discard
gasket.
H
C
H
C
B
I
G
F
E
A
C Screw
G Fuel Pump Bracket
A
D
D Inlet Fuel Line
H Nut
14 690 10 Rev. --