Advertisement
Connecting Alarm Input / Output
Weather Resistant Network Coupler
1. Loosen the nut from the Weather Resistant Network Coupler,
2. Run ethernet cable through coupler, then attach a RJ-45 connector.
3. Tighten the nut and coupler for a weather resistant seal.
Wall or Ceiling Mounting: Make sure the wall or ceiling can support 3X the
device's weight. Install in dry conditions, free of dust and debris.
1. Drill the screw holes and the
cable hole on the wall according to
the drill template.
2.54"
2.54"
Install SD Card
1. Remove the MicroSD card slot cover.
2. Insert a MicroSD card.
3. Check if the water-resistant ring is
installed properly before re-installing the slot
cover. Tighten screws firmly.
2. Route the cables and connect the relevant cables.
3. Fasten the mounting base to the wall/ceiling with
the screws provided.
.2" / 5mm
3
Advertisement
