Rigging procedures
General principles
Because of the highly-modular nature of the rigging system, not all possible congurations are described in the rigging
procedures. This introduction provides general principles applicable for all congurations.
References
For information on radial congurations with A10i-LIFT, refer to
(p.124).
For information on wall-mounted or ceiling-mounted congurations with A-U15i and A-U10i, refer to
Congurations with A-U15i / A-U10i
To know the site angle of the rst enclosure secured on A10i-TILT, refer to
(p.98).
Securing rigging plates on an enclosure
• Follow the curvature of the front of the enclosure when securing the rigging plates.
• Make sure that the inserts for the screens are accessible.
Driving screws
Do not fully tighten the screws unless otherwise instructed.
Follow the indicated torque when tightening a screw.
A10i owner's manual (EN) version 1.0
(p.126).
APPENDIX A: Authorized congurations with A10i-LIFT
Realized site angles (with A10i-TILT at the rear)
Rigging procedures
APPENDIX B:
55