L-Acoustics A10i Owner's Manual page 61

4. Secure the additional A10i Wide/Focus under the array:
This step requires three operators.
a)
Hold the enclosure at the bottom until the rigging plates are secured.
Lift the rear of the new A10i Wide/Focus and secure it to the array by pre-tightening a rigging screw on both
sides.
A10i Focus site angle adjustment
A10iFOCUS-LINK can be used to add an inter-element angle of 5° between two A10i Focus.
b) Remove the rigging screws at the bottom front on both sides of the top A10i Wide/Focus.
c) Link the A10i Wide/Focus enclosures at the front with rigging screws.
d) Tighten all the screws on the supporting A10i Wide/Focus.
Apply a torque of 5 N.m.
A10i owner's manual (EN) version 1.0
Rigging procedures
61