Adding A Pullback With A10I-Rigbar Or A15I-Rigbar - L-Acoustics A10i Owner's Manual

Adding a pullback with A10i-RIGBAR or A15i-RIGBAR

Type of deployment
Rigging accessories
Additional accessories
Min number of operators
Risk of falling objects
Verify that no unattached items remain on the product or assembly.
Secondary safety
Use available holes on the rigging accessories to implement a secondary safety.
Assembly
Procedure
1. Prepare a vertical array as described in
vertical array with A10i-RIGBAR or A15i-RIGBAR
2. Raise the array until the bottom enclosure is accessible.
3. Remove the screw from the bottom rear hole of the bottom enclosure on each side.
4. Secure A10i-RIGBAR at the bottom rear of the bottom enclosure.
A10i owner's manual (EN) version 1.0
own array with pullback
A10i-RIGBAR / A15i-RIGBAR
1 x Ø12 mm shackle WLL 1 t (provided)
M6x40 screws (provided)
M6x18 rigging screws (provided)
T30 Torx bit
1
Flying a vertical array with A10i-BUMP or A15i-BUMP
(p.71).
Rigging procedures
(p.59) or Flying a
73