Leds; Table 2-6 Parameters Of The Ge Interface Based On 10/100/1000Base-T Standard; Table 2-7 Leds On The Gpsc Card - Raisecom ISCOM5508-GP Hardware Description

Raisecom
ISCOM5508-GP (A) Hardware Description
Table 2-6 lists parameters of the GE interface.

Table 2-6 Parameters of the GE interface based on 10/100/1000BASE-T standard

Connector
Working mode
Cable specifications
Compliant standard
Supported network protocol

2.2.4 LEDs

There are 16 LEDs on the GPSC card, among which 6 LEDs are integrated on the RJ45
interface.
Table 2-7 lists LEDs on the GPSC card.

Table 2-7 LEDs on the GPSC card

PWR
SYS
LINK/ACT
3/4/5/6
(SFP optical
interface)
LINK/ACT
1/2
(RJ45 electrical
interface
integrated LED)
Parameter
LED Status
Green
Green
Green
Green
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
RJ45

10/100/1000 Mbit/s auto-negotiation
 Full duplex and half duplex auto-negotiation
 When the device works at 10 Mbit/s or 100 Mbit/s, we
recommend using the Cat 5 UTP cable.
 When the device works at 1000 Mbit/s, we recommend
using Cat 5e STP cable.
IEEE 802.3
IP
Power LED

Green: the power supply is working properly.
 Off: the power supply is working improperly.
System working LED
 Fast blinking green (4 Hz): the system is initializing.
 Slow blinking green (0.5 Hz): the system is working
properly.

Off: the system is working improperly.
Line working LED

Green: the interface is connected properly.

Blinking green: the interface is transmitting data.

Off: the interface is disconnected or connected
improperly.
Line working LED

Green: the interface is connected properly and no data is
being transmitted.

Blinking green: the interface is transmitting data.

Off: the interface is disconnected or connected
improperly.
2 1BComponents
Description
Description
10