Leds; Table 2-5 Parameters Of The Snmp Interface; Table 2-6 Leds On The Mcua Card - Raisecom ISCOM6820-GP Hardware Description

Raisecom
ISCOM6820-GP (A) Hardware Description
Baud rate
Cable specifications
Table 2-5 lists parameters of the SNMP interface.

Table 2-5 Parameters of the SNMP interface

Connector
Interface rate
Wiring
Compliance
standard

2.2.4 LEDs

There are 4 LEDs on the MCUA card, where 2 LEDs are integrated with the 10GE Ethernet
optical interface.
Table 2-6 lists LEDs on the MCUA card.

Table 2-6 LEDs on the MCUA card

ACT
SYS/ALM
LINK/ACT
1/2
(SFP+ optical
interface)
Parameter
115200 baud
4-core shielded cable
Parameter
RJ45
10/100/1000 BASE-T auto-negotiation
Support adaption to straight-through/crossover cable in host mode
IEEE 802.3
LED Status
Green
Three
colors
Green
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Description
 On: the card is the active card.
 Off: the card is the backup card.
System working LED
 Blinking green every 1s: the card works normally.
 Blinking green every 0.25s: the card is initiating and
loading.
 Red (On): the system fails (the backplane fails).

Red (Off): the card is not properly inserted.
 Orange (On): the card is in Standby mode.
 Orange (Off): the system works abnormally.
Line working LED
 Green: the interface is connected properly.

Blinking green: the interface is transmitting data.

Off: the interface is disconnected or connected
improperly.
Description
2 Components
10