Rigid Industries E Series Mounting Instructions
40" upper grille for ford raptor
Hide thumbs
Also See for E Series:
- Installation instructions manual (10 pages) ,
- Installation instructions (2 pages) ,
- Product instructions (2 pages)
Advertisement
Quick Links
®
upper grille
Ford® raptor®
40" E-Series
upper grille
mounting instructions
Thank you for purchasing Rigid Industries' products for your Ford®.
Installation is fairly simple with the right tools and good mechanical abilities.
If you are not con dent in your mechanical skills, please seek the help of a
professional to perform the installation. Please read through all of these
instructions and tips before proceeding with installation.
Advertisement
Related Manuals for Rigid Industries E Series
Summary of Contents for Rigid Industries E Series
- Page 1 Thank you for purchasing Rigid Industries’ products for your Ford®. Installation is fairly simple with the right tools and good mechanical abilities. If you are not con dent in your mechanical skills, please seek the help of a professional to perform the installation.
- Page 2 Always disconnect battery before servicing any fuses or electrical system. Step 1 The 40” E-Series mounts behind the existing main grille. Open the hood and notice the two black bumpers on both sides of the grille opening towards the bottom. Behind those bumpers are two Torx head screws, remove the screws and the nut clips that the bolts are threaded into.
- Page 3 Wiring Instructions - Auxiliary switches Your Raptor is equipped with four factory “Up tter” auxiliary switches. These need to be connected to the OEM output wires. There are two locations that need to be addressed; inside the glove box and inside the engine compartment under the hood. step 3 Open the glove box normally and empty out.
- Page 4 Glove box tab released. Wiring bundles after access panel is removed. step 4 In order to get the switch outputs connected to the pass through wiring that terminates under the hood for Step 7, you need to make the connections below and behind the glove box.
- Page 6 Amperage ratings for the OEM switch outputs and a list of required amperage for Rigid Industries Lighting is available in the table on the following page.
- Page 7 Fuse Ratings Recommended for Rigid Industries LED Lights 50” E-Series 20 amp fuse 40” E-Series 20 amp fuse 20” E-Series 10 amp fuse Dually/D2 (Pair) 5 amp fuse Wires before mating to Rigid Industries wiring harness. Switch 1 Red Wire...
- Page 8 RigidIndustries.com Warranty Information Rigid Industries warrants that this product will be free from defects in material and workmanship. If you believe your Rigid Industries product is defective, it must be returned to Rigid Industries for inspection by our warranty claims department.