Rigid Industries E Series Mounting Instructions page 7

Fuse Ratings Recommended for Rigid Industries LED Lights
Wires before mating to
Rigid Industries wiring harness.
Engine compartment wiring connected to light harness.
step 7
On the passenger side of the truck, locate the under hood OEM wiring above
the wheel well. There will be four colors; red, green, violet, and blue, with heat
shrink around the ends. Refer to your owner's manual if you need help locating
these wires. These are the switch outputs that we connected under the dash
in Step 4. Connect the power wire from the wiring harness provided in your kit
to the switch output desired. Route the other end (male weather pack connector)
down behind the headlight bucket and over to the grill area to your light bar.
The black ground wire can be grounded to passenger side inner fender by using a
factory bolt location or by using a self-drilling tek screw.
Standard grounding principles apply.
Congratulations!
your Rigid Industries LED lights
50" E-Series
40" E-Series
20" E-Series
Dually/D2 (Pair)
are now installed!
20 amp fuse
20 amp fuse
10 amp fuse
5 amp fuse
Switch 1
Switch 2
Switch 3
Switch 4
- Red Wire
- Green Wire
- Blue Wire
- Purple Wire