Dell EqualLogic PS Series Installation And Setup page 36

Installation and Setup
Note: Make sure you keep the serial cable. You can use the serial cable to manage
the group or array if there is no network access.
Obtain the serial cable that was shipped with the array and attach the cable to the
serial port on the active control module (ACT LED will be green) and to a console
terminal or a computer running a terminal emulator. See Figure 2-18.
Make sure the serial connection has the following characteristics:
• 9600 baud
• One STOP bit
• No parity
• 8 data bits
• No hardware flow control
Figure 2-18: Connecting the Serial Cable
After completing the hardware installation, see Chapter 3, Software
Configuration.
2–24
Installing Array Hardware