Step 4: Set Up A Serial Connection To The Ps5500 - Dell EqualLogic PS Series Installation And Setup

Installation and Setup
Figure 2-17: Detaching the Bezel from the Chassis
4. Press the blue power button on the front panel.
Note: Batteries will start to charge and some hardware components will start to
synchronize when power is turned on. Array LEDs may indicate this on-
going activity, which is normal array behavior.
To install and lock the bezel:
1. Facing the front of the rack, fit the right side of the bezel into the right side of
the chassis.
2. Push the bezel toward the chassis until the left side of the bezel engages with
the chassis.
3. Insert the bezel key and turn it counter-clockwise to lock the bezel to the
chassis.

Step 4: Set Up a Serial Connection to the PS5500

If you plan to use the
serial connection. If you plan to use the Remote Setup Wizard, you do not need a
serial connection. See Step 1: Choose a Configuration Method on page 3-1 for
information about Remote Setup Wizard requirements.
utility to configure the software, you must set up a
setup
Installing Array Hardware
2–23