REMOTE ACCESS CONTROL
AIR CONDITIONER UNIT COMMUNICATION FEATURES (OPTIONAL)
An optional communication board offers capabilities that include Pr����
protocols through Ethernet and Modbus RTU protocol via USB. nVent has a PC Interface Tool available for
download that can utilize either mode to communicate with the air conditioner unit.
USB COMMUNICATION
This communication mode allows direct connection of a PC to the air conditioner unit. The protocol
supported is Modbus RTU. Use the nVent AC monitor to communicate with the air conditioner unit. A
MINI-b USB connection is included with this option.
ETHERNET COMMUNICATION
This communication mode allows remote connection to the air conditioner unit using SNMP , EtherNet/IP
and Modbus/TCP, and Pr��� p rotocols. Customers using their own software can download a MIB��
for SNMP�������
��
for Pr���
Note: The ACU has a default IP Address of 192.168.1.2
Both Ethernet and USB communication modes allow the ability to:
•
Read ACU inlet and outlet air temperature
•
Read and change Cooling Setpoint and Cooling Differential
•
Read and change High and Low Temperature Alarm Settings
•
Read and change Gateway IP Address, Device IP Address, Subnet Mask, Trap IP Address and SNMP Community
•
Read and change ���������
•
Read and change the type of IP addressing (static or dynamic)
•
Read current Alarm Status
•
Read MAC Address
•
Read and change the door open and/or smoke detected switch functionality
C-NET INDUSTRIAL LTD. | +44(0)121 544 8608 | INFO@CNET-IS.CO.UK | WWW.CNET-IS.CO.UK
89116616
EhterNet/IP O�������������
E therNet/IP, Modbus TCP, and SNMP
, Coil Register ��
for Modbus TCP, and GSDML
- 21 -