Advertisement
OPERATING INSTRUCTIONS
1.
Use a sufficiently powerful tractor which is heavy enough
to tow the drill in a safe way.
2.
Hydraulic Fan, connect the hoses in the following order:
First: connect the Case Drain line 3/8" hose to the
hydraulic reservoir.
IMPORTANT: THE HYDRAULIC RESERVOIR OR
WHAT CASE DRAIN LINE CONNECTED SHOULD
HAVE NO BACKPRESSURE.
Second: connect Blower Outlet line 3/4"hose to tractor
return port.
Finally: connect Blower Inlet line 3/4"hose to tractor
power port.
Disconnect in the reverse order to prevent motor seal
damage.
3.
Connect the inlet & outlet line of lifting circuit and folding
circuit in correct tractor hydraulic ports.
4.
Check tyres pressure before seeding.
5.
Check lubrication before seeding.
6.
Adjust the drills or double-disc openers to proper working
loads. Boots and air pipes are connected well.
7.
Set the working depth of the machine through depth control
valves.
8.
Check the levelling of the machine at the working height.
9.
Calibrate each compartment before seeding.
10. Fulfil the hopper, close hopper doors, and pack up ladder.
11. Raise the air drill before moving to the field.
12. Raise the air drill when turning during the operation.
13. Operate the air drill at a speed of 8-12 km/hr (5-7.5 mph).
14. After long term storage, check to see that all drive
mechanism and hydraulic equipment are functioning
correctly. Check that the air tubes are not blocked and
perished.
21 21
05.19M142J3
Advertisement
