Advertisement
PROCEDURE FOR RESETTING GATES IF REQUIRED:
1. Empty the hopper or close the hopper gate and uninstall
the seed cup from the hopper.
2. Use 8mm wrench to loosen wing nut and free the
adjustment handle.
3. Adjust the handle to a proper position according to the
„GRAIN &FERTILIZER CHART‟.
4. Hold the wing nut and use the wrench to lock the handle
tight.
„NORMAL‟ POSITION is suitable for most seed and fertilisers:
Oats, Barley, Sunflower, Rice, etc.
„COARSE‟ POSITION is suitable for large seeds and higher
rate:
Lupin, Soybean, etc.
„COARSE‟ Position is also usable when cleaning or change
products in the tank.
„FINE‟ POSITION is suitable for small seeds and lower rate:
Lucerne, Canary, Canola, Millet, etc.
GEARBOX SETTINGS
The calibration is powered by the electric motor and controlled
through John Shearer App on the tablet; therefore a proper
setting is important for an accurate calibration.
The quick switch gears can be set to allow the electric motor rate
between low to high, and special sets of gears are available to
meet lower volume needs. The charts on pages 22-30 are a
guide to what rate can be expected for various products. Be
aware that this chart is a guide only, and for accuracy, a
calibration check must be done before seeding.
The drawn shows normal sitting position of how two pair of gears
fit into 16 to 27 gear ratio.
It is important to keep gears facing the right direction and
position when switching the gear ratio.
15 15
05.19M142J3
Advertisement
