Precautions For Disassembly; Removing The Tx-Rx Unit And Other Parts - Kenwood NX-1200 Series Service Manual

3.1

Precautions for Disassembly

3.1.1 Removing the TX-RX unit and other parts.

(1) Loosen CAP screw and remove the CAP.<1>
(2) Remove Volume Knob & Selector Knob.<2>
(3) Remove the two screws tightened on Chassis. <3>
<1>
<3>
<3>
(4) Lift the bottom of the chassis and remove it from the front
case.
(5) Remove Rubber Seal of phone jack and Rubber Seal at top
side.
1-16 (No.RA077<Rev.001>)
SECTION 3
DISASSEMBLY
<2>
<2>
MIC+
(6) Remove Speaker Holder Assy from Chassis.
Press on the hooking portion of Speaker Holder and
remove the Speaker Holder Assy from Chassis.
Note:
Please be cautious the wires are still connected to
Speaker and MIC element.
Desolder to remove the Holder Assy.
Speaker Wires x2
MIC Wires x2
32M
MIC-
SP-
SP+
MICO
Holder Assy
Holder Assy is fixed by this hook.
Press
SP-
SP+
MIC- MIC+