Supplied Accessories Of "Service Tx-Rx Unit"; "Service Tx-Rx Unit" Data; After Changing The Pcb; Model Name Plate Label Layout - Kenwood NX-1200 Series Service Manual

Supplied Accessories of "Service TX-RX unit"
Item
TX-RX Unit
Model Name Plate Label
(KENWOOD ESN/ NXDN ESN)
"Service TX-RX unit" Data
The following data is written into the service unit:
Data Type
KENWOOD ESN Model name: NX-1200DS
Type:K
The same number as the Model Name
Plate Label is written.
NXDN ESN The same number as the Model Name
Plate Label is written.
* In the case of NX-1200D (K) or NX-1200DV (K)
After Changing the PCB
(1) Using the KPG-D6/ KPG-D6N, select your desired item
(Model Name and Frequency) from the Model> Product
Information menu, then use Program> Write Data to the
Transceiver to write the FPU data (PC Programming
mode). When writing to the transceiver, a Warning
Message, corresponding to the item selected, appears.
Click [OK] to continue writing the data.
(2) Enter Program> Test Mode, then adjust the various
adjustment data (PC Test Mode) as described in the
"SECTION 4 ADJUSTMENT".
(3) Stick the Model Name Plate Label corresponding to the
new printed circuit board. (Refer to the below image for the
label sticking position.)
(4) If necessary, write the FPU data used by the customer with
the KPG-D6/ KPG-D6N.
Note:
• When a new printed circuit board is used, the
KENWOOD ESN changes, as does the Transceiver
Information display of the KPG-D6/ KPG-D6N, but this
does not have any effect on the operation of the
transceiver.
• If changing to the original ESN, please contact our
service center.
Quantity
1
1
Description
Model Name Plate Label Layout
KENWOOD ESN
NXDN ESN
Model Name Plate Label
(No.RA077<Rev.001>)1-49