Installation; Precautions; Fixed Station; Grounding - Kenwood TS-440S Instruction Manual

2. INSTALLATION
2-1. PRECAUTION
. Avoid direct sunlight, and select a dry, well venti-
lated location.
Since the heat sink is on the rear panel, avoid piac-
ing the equipment with the bottom and rear sides
close to a wall or desk.
. When installing the equipment in an automabile, en-
sure adequate ventilation, Install the equipment in
N
@
2-2. FIXED STATION
2-2-1. Interconnection
The TS-440S requires more than 18A at 13.8 VDC
when transmitting at full power. Use the PS-50 or
PS-430 power supply for fixed stations.
Note: ;
The PS-50 base station supply is needed for continu-
ous transmission operation.
PS-50 —_ >
TS-4408
To antenna
2-2-2. Grounding
Caution:
Never use a gas pipe or electrical conduit pipe.
Notes:
1. A ground connection that is a 1/4 wavelength or
its multiple may provide a good DC ground, but it
will not provide a good RF ground.
. A city water pipe cannot be used as a good earth
in some cases,
N
a location where the rear does not make direct con-
tact with the seat, and is not directly exposed to
vibration.
4. Avoid installing the equipment in front of the car
heater air outlet.
5. The standard operating voltage of the equipment
is 13.8 V. Do not operate below 12 V or over 16V.
The transceiver can be elevated for operating con-
venience.
Caution:
Do not use the bail to carry the transceiver.
Making a good earth connection is important for
preventing dangers such as electric shock and for emit-
ting a high quality signal with minimum spurious radi-
ation. Bury a commercially available ground rod or
copper plate under the ground and connect it to the
GND terminal of the TS-440S. A thick wire, cut as
short as possible, should be used for the connection.
To make a good earth connection, connect the GND
terminal to a grounded metal water pipe.
4