Cut Didn't Go Through Material; 900 Cooler Off - Flux Beambox User Manual

8.2 Cut Didn't Go Through Material

1
Go to touch panel > Maintenance, make sure
power is set to "x1.0".
2
Check if the focus is adjusted at the right height.
3
Check if the lens or mirrors are dirty or damaged.
4
Check if the optical path is aligned.
5
If the solutions above didn't work, please contact
FLUX Support.

8.3 #900 Cooler Off

1
Press "Continue", if the error message does not
pop up again within one minute, the machine should
operate normally.
2
Please check if the water level of the cooling tank
is at least half full.
91