Leather - Flux Beambox User Manual

・ Engraving results on wood
The slower the speed, the darker the engraved result.
The higher the power, the deeper the cutting depth.
To achieve a darker effect, slowing down the speed is
usually more useful than raising the power.
・ How To Prevent Burn Marks On Wood
Cover the surface with masking tape prior to printing,
or remove the marks with sandpaper. The alternative
is to slightly wet the wood, but it might cause bumps
on the surface.
・ How To Reduce Burn Edge On Wood
Clean t he e d g e s wi t h alco hol or s oapy w ater, or
choose wood with lower density, so the cutting speed
can be faster, leaving lighter edge marks.

5.3 Leather

・ Types Of Leather
Synthetic Leather
The surface of the synthetic leather is mainly divided
into two kinds of materials: PU (polyurethane) or PVC
42