Table of Contents
Advertisement
Troubleshooting
If you have issues connecting the camera to the account, power cycle the camera and try again.
If issues persist, reset the camera to factory defaults by following these steps:
1. Disconnect the camera from the power supply.
2. Use the Hex Key to remove the water-tight door on the bottom of the camera and locate the Reset button.
3. Press and hold the Reset button while reconnecting power. Continue to hold the Reset button for 10 seconds.
Questions?
Visit:
www.alarm.com/supportcenter
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Mini_Bullet_ADC-VC7
Updated: Wed, 19 Jun 2019 01:30:58 GMT
2
Advertisement
Table of Contents
Need help?
Do you have a question about the ADC-VC726 and is the answer not in the manual?
Questions and answers