Component Description; Introduction; Power Supply - Televes TOX Series Manual

4. Component Description

4.1. MUX DVBS2-IP CI/ MUX DVBT2-IP CI
1
2
1. Refs. 565840/565801:
Satellite IF input (input 0)
Refs. 565740/565701:
DVB-T / DVB-T2 input
The satellite input mux (refs. 565840, 565801) can
demodulate up to three DVBS or DVBS2 signals
from one or two IF inputs.
Terrestrial input multiplexer (refs: 565740,
565701) can demodulate up to four DVBT or
DVBT2 signals.

4.2. Power Supply

Connectors to
power modules
(1)
Mass
LED status indicator
24V 24V 0V
24V 0V 24V
24V: OK
0V: Overload or short circuit
NOTE: - The power supply may power up to seven modules with CAM, with only 2 active LNB powering operations, split in any of the modules.
- Upon inserting the CAM, consumption may increase by an average of 70mA, as it may vary from 20mA to 100mA based on the CAM. Each
active LNB/Pre-amp increases consumption by about 250mA, depending on the LNB.
- Both of the supply's outputs must be used when consumption of one of them is over 4A (maximum current in each output).
PWR
ETH 1
ETH 2
CAM
REF. 565840
U3Q-IP-S2-CI
MADE IN SPAIN
565840/ 565740/
565801
2. Refs. 565840/565801:
Satellite IF input (input 1)/output
Refs. 565740/565701:
DVB-T / DVB-T2 output
All references allow for the creation of up to 32
SPTS IP outputs, selecting the service to be broad-
cast over IP for each of them. They also have a
Common Interface slot for inserting a conditional
access module (CAM) that allows services to be
descrambled.
02340039001 003
NETWORK input
~230V
3
PWR
4
5
6
ETH 1
ETH 2
7
CAM
8
REF. 565740
U3C-IP-CI
MADE IN SPAIN
565701
3. Power module input
4. LED status indicator
5. Top Ethernet connector
6. Bottom Ethernet connector
References 565840/565740 have the option to
re-encrypt services previously descrambled with
the CAM module through the DRM Pro:Idiom sys-
tem. If this option is selected, the number of ser-
vices to be descrambled is limited to eight.
Multiplexers are set up on a web interface.
(1)
Insert the card all the way into the CAM
with the contacts to the left and to the
front before connecting the power
supply to the module.
7. Micro USB connector
8. CAM input
9
EN