Operating Instructions
How to Use the Remote Control
TURNING THE UNIT ON
Plug in the unit, then press the "
before shutdown.
To switch the unit off, press "
Do NOT switch the unit off by removing the plug.
Always switch the unit off by pressing the "
Change temperature setting
During Auto or Cool mode, press the
by 1
ºF or press the
The set temperature can be change in a range of 60 ºF to 90 ºF.
Change fan speed setting
During Auto, Cool or Fan mode, press the "
Low
°F/°C function
"
"
Press the
and
between degree Fahrenheit and degrees Celsius.
Note: Under Dry/Fan mode, you can not select C.
Fault Code
If the screen on the unit displays
"AS", the room temperature sensor
has failed. Contact your Authorize
Frigidaire Service Center.
If the screen on the unit displays
"ES", the pipe temperature sensor
has failed. Contact your Authorize
Frigidaire Service Center.
©
" button (when turned on, the unit will operate as the last setting
" button again, then remove the plug.
"
" to decrease the set temperature
" + "
button to increase the set temperature by 1 ºF.
Med
" + "
button the same time for more than 3 seconds to switch
" button and wait for few minutes before removing the plug.
" button to select the desired fan speed. As show below.
Hi
If the display reads "E4" , the communication
between display PCB and main control PCB
is faulty. Contact your Authorized Frigidaire
Service Center.
If the screen on the unit displays "P1", the water
collection tank inside the unit should be full.
Refer to the "Drainage Instructions" on Page
15 for more instructions to drain the
successive condensate. If error repeats,
contact your Authorize Frigidaire Service Center.
Auto
All rights reserved.
Need help?
Do you have a question about the GALLERY GHPC132AB1 and is the answer not in the manual?