Saxby Lighting Sight Twin Spot Instruction Leaflet

Fitting/replacing bulbs

Battery Replacement

lit for the three hour period, a new battery pack may be
required.
fully discharge then reconnect to supply and allow to
charge for 24 hours.
change the battery pack as follows:
from fitting. Keep screw safe for refitting later.
PCB. Remove any cable ties around the cables.
not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority or
retailer for recycling advice.

Cleaning Information

wash
with warm water or just use a damp cloth.

Recycling advice

Check with your Local Authority or retailer for recycling advice.

Safety information

Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
This bulbs are protected by shades. This part must be replaced immediately should the shades
become cracked or damaged. This fitting must not be used without the shades in place.
Replace Cracked Shade
WWW.saxbylighting.com
3.6V 4500mAh Ni-Cd ONLY.
the screws set aside earlier. Refit the cable ties in
position and then plug battery pack into the PCB.
finish.
V2 14/02/2020
Saxby lighting. BH17 7BY
Saxby Lighting. BH23 3PE
Instruction leaflet
Sight Twin Spot
72642