Table of Contents
Advertisement
AXIS C8033 Network Audio Bridge
About events
About events
The event pages allow you to configure the product to perform actions when different events occur. For example, the product can
play an audio clip according to a schedule or when a call is received. The set of conditions that defines how and when the action
is triggered is called an action rule.
How to set up action rules
An action rule defines the conditions that must be met for the product to perform an action, for example play an audio clip or send a
notification message. If multiple conditions are defined, all of them must be met to trigger the action.
For more information about available triggers and actions, see About triggers on page 21 and About actions on page 22.
The following example describes how to set up an action rule to play an audio file when the Axis product receives an input signal
from a video management system.
1. Go to Events > Action Rules and click Add.
2. Select Enable rule and enter a descriptive name for the rule.
3. Select Input Signal from the Trigger drop-down list.
4. Select Virtual Inputs from the second drop-down list.
5. Select 1 from the third drop-down list.
6. Select Yes in the Active list.
7. Optionally, select a Schedule and Additional conditions. See below.
8. Under Actions, select Play Audio Clip from the Type drop-down list.
9. Select the desired audio file from the Play drop-down list.
10. Click OK.
To use more than one trigger for the action rule, select Additional conditions and click Add to add additional triggers. When using
additional conditions, all conditions must be met to trigger the action.
To prevent an action from being triggered repeatedly, a Wait at least time can be set. Enter the time in hours, minutes and seconds,
during which the trigger should be ignored before the action rule can be activated again.
For more information, see the online help
About triggers
Available action rule triggers and conditions include:
•
Applications – Use installed applications to trigger the rule. See About applications on page 19.
•
Detectors
•
Call
-
State – Triggers an action rule when a call service state changes to active, calling, idle or ringing. This trigger
can, for example, be used to play a dial tone when a call is connecting.
-
State Change – Triggers an action rule when a call state changes. This trigger can for example, be used to play a
busy tone when a call is busy.
•
Hardware
.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
21
Advertisement
Table of Contents
