Related Manuals for Pulsar PSAC 04244
Summary of Contents for Pulsar PSAC 04244
- Page 1 PSAC 04244 v.1.1 PSAC 24VAC/4A/4x1A AC power supply for up to 4 analog cameras. Edition: 5 from 25.05.2015 Supersedes the edition: 4 from 05.11.2014...
-
Page 2: Table Of Contents
1.1. General description. power supply is designed to supply analog cameras or other devices requiring The AC/AC PSAC 04244 stabilized voltage of 24V AC or 27V AC and total capacity of 4A@24V AC 24V AC or 27V AC and total capacity of 4A@24V AC. -
Page 3: Block Diagram
PSAC04244 1.2. Block diagram. Fig.1. Block diagram of the PSU. 1.3. Description of PSU components and connectors Tab.1. Terminals and elements of LB4/24V/27V/AW- fuse strip (module). Element no. Description [Fig. 2] L1÷L4 - LEDs (green) indicating L1=AUX1 output status F1÷F4 fuses in AUX circuits, F1=AUX1 etc. - Page 4 PSAC04244 Fig.2. View of the LB4/24/27/AW strip. Tab.2. Terminals and elements of the PSAC 04244 power supply unit. Element no. Description [Fig. 4] Isolation transformer Fuse strip (module) LB4/24V/27V/AW (tab. 1) TAMPER, tampering connector (NC) F fuse in the power supply circuit (230V AC)
-
Page 5: Specifications
PSAC04244 Fig.4. The view of the PSU. 1.4 Specifications: - electrical specifications (tab.3) - mechanical specifications (tab.4) - operation safety (tab.5) - operating specifications (tab.6) Electrical specifications (tab. 3). Mains supply 230V AC (-15%/+10%) Current consumption 0,5 A max. -
Page 6: Installation
PSAC04244 - glass fuse damage requires fuse-element replacement circuit AC 24 V: 4x F 1,0A or PTC 1A Overload protection OLP circuit AC 230V: T 1A Surge protection varistors Overheat protection OHP inside transformer Sabotage protection: - microswitch, NC contacts (enclosure closed), - TAMPER output indicating enclosure 0,5A@50 V DC (max.) -
Page 7: Installation Procedure
PSAC04244 2.2 Installation procedure. 1). Before installation, make sure that the voltage in the 230V power-supply circuit is cut off. 2). Mount the PSU in a selected location and connect the wires. 3). Connect the power cables to the L-N terminals. Connect the ground wire to the terminal marked by the earth symbol –... -
Page 8: Operation And Use
WEEE separately. GENERAL WARRANTY CONDITIONS 1. Pulsar (the manufacturer) grants a five-year warranty for the equipment, counted from the device’s production date. 2. The warranty includes free-of-charge repair or replacement with an appropriate equivalent (the selection is at the manufacturer’s discretion) if the malfunction is due to the manufacturer, includes manufacturing or material defects, unless such...
Need help?
Do you have a question about the PSAC 04244 and is the answer not in the manual?
Questions and answers