Electrical Fuses - Mercedes-Benz G-Class Owner's Manual

X
Pull out bolt ;.
X
Pull out raising/lashing point ? until the
bolt recess is in position =.
X
Insert bolt ; into position =.
X
Insert securing split pin : once again.
Recovering a vehicle that has become
stuck
!
When recovering a vehicle that has
become stuck, pull it as smoothly and
evenly as possible. If the tractive power is
too high, the vehicles could be damaged.
If the drive wheels get trapped on loose or
muddy ground, recover the vehicle with the
utmost care, especially so if the vehicle is
laden.
Never attempt to recover a vehicle with a
trailer attached.
Pull out the vehicle backwards, if possible,
using the tracks it made when it became
stuck.
Towing in the event of malfunctions
General notes
! Always use new self-locking nuts when
fitting the propeller shafts.
X
Observe the safety notes as you do so
( Y page 166).
i Consult a Mercedes-Benz Service Centre.
Engine damage, gear damage or electri-
cal faults
X
Move the selector lever to posi-
tion N( Y page 91).
X
Shift the transfer case to neu-
tral( Y page 111).
In the event of damage to the transfer
case
Have the propeller shafts between the axles
and the transfer case removed.
In the event of damage to the front axle
Have the propeller shaft between the rear
axle and the transfer case removed.
Have the vehicle towed with the front axle
raised.
In the event of damage to the rear axle
Have the propeller shaft between the front
axle and the transfer case removed.
Then, have the vehicle towed with the rear
axle raised and with wheel rollers under the
front axle.

Electrical fuses

Important safety notes
G
WARNING
If you manipulate, bridge or replace a faulty
fuse with a fuse of a higher amperage, the
electric cables could be overloaded. This may
result in a fire. There is a risk of an accident
and injury.
Always replace faulty fuses with specified new
fuses of the correct amperage.
!
Only use fuses that have been approved
for Mercedes-Benz vehicles and which
have the correct fuse rating for the system
concerned. Otherwise, components or sys-
tems could be damaged.
Electrical fuses
Z
169