1.8
Industrial printer: B-EX4T1 / B-EX4T2 / B-EX4D2
c) '0.1 km counter' reading
1. As you switch the printer on, hold down the [FEED] and [PAUSE] keys or the
[MODE] key. Release the keys when '<1> DIAG' appears on the display. The
printer is now in System mode for system administrators.
2. Confirm '<1> DIAG' by pressing the [PAUSE] key.
3. Confirm PRINT TYPE by pressing the [PAUSE] key, check the configured print
process (Transfer/Direct), and change if necessary. You can move the cursor by
pressing on [FEED] and [RESTART] and can confirm your selection by pressing
on the [PAUSE] key.
4. Press the [FEED] key until [CHECKING & PRINT] appears on the display and
confirm your selection by pressing the [PAUSE] key.
The counter reading is now printed out.
Once printing is complete, turn off the device and then on again.
Page 12