B) 'Cm/Inch Counter' Reading - Toshiba B-EP2 Counter Reading Manual

Mid-range printer: B-SA4TP / B-SA4TM

b) 'Cm/inch counter' reading

Note:
- FW update for 'cm/inch counter' may be required.
o B-SA4T Series, FW version: B-SA_MAIN_C2.1
o B-SA4T Series, Boot version: B-SA_BOOT_1.2A
- The new/additional 'cm/inch counter' is available for use as soon as the new FW is
installed.
- There is no conversion of the previous counter reading in 0.1 km in
MAINTENANCE CONT.
- The '0.1 km' counter in MAINTENANCE CONT is not added to the 'cm/inch
counter.'
2. Press the [PAUSE] key.
4. Hold the [FEED] key down
until the counter is shown on
the display.
6. Press the [RESTART]
key to choose between
'cm' and 'inch.'
1. The system is in ONLINE mode
when switched on.
3. [PAUSE] is shown on the display.
5. The counter is shown in 'cm' and 'inch' on
the display.
7. Press the [PAUSE] key to print out the
counter reading. The Normal mode in
Step 1 is shown again once printing is
complete. If you do not wish for the
counter reading to be printed, press
the [FEED] key to display the Normal
mode in Step 1.
Page 8