Table of Contents
Advertisement
(2) Constant-dimension stitching pattern
OFF
2
Sewing pattern
CD
OFF
3
4) Four different kinds of stitching patterns can be performed according to the combination of ON/OFF
settings of automatic reverse stitching (for start) switch 2 and automatic reverse stitching (for end)
switch 3 .
5) Furthermore, the double reverse stitching mode can be specified by operating double reverse stitching (for
start) switch 7 and double reverse stitching (for end) switch 8 .
6) If automatic thread trimming switch 6 is turned ON, the sewing machine will automatically perform
thread trimming after it finishes the predetermined number of stitches between C and D. (If the automatic
reverse feed stitching (for end) is selected, the sewing machine will automatically perform thread
trimming after it finishes the automatic reverse stitching (for end) even when the automatic thread
trimming switch is not selected.)
If automatic thread trimming switch 6 is turned OFF, operate the touch-back switch after the completion
of processes C and D. Then the machine runs at a low speed (stitch compensation operation).
Also, if the pedal is returned to its neutral position and depressed its front part again, the sewing can be
continued regardless of the setting of number of stitches.
7) If thread trimming prohibiting function 9 is chosen, the machine will stop with the needle up without
performing thread trimming.
8) If one-shot automatic stitching function !0 is chosen, the machine will automatically perform sewing at a
stretch, at the specified speed by depressing the front part of the pedal.
7 2
8 3
1
ON
OFF
ON
A
A
B
B
CD
CD
CD
B
B
A
A
OFF
ON
ON
4
5
6
1) Press constant-dimension stitching pattern
switch 1 on the control panel to select the
constant-dimension stitching pattern.
2) The constant-dimension stitching pattern is
selected. Now, the predetermined number
of stitches and the state of reverse stitching
function are shown on the control panel.
3) To change the number of stitches of the
processes in the constant-dimension stitching
pattern, change the number of stitches for
processes C and D by operating switches 5
for setting the number of stitches for processes
C and D. Select the reverse feed stitching
accordingly. To change the number of reverse-
feed stitches, operate switches 4 for setting the
number of stitches for processes A and B.
Adjusting range : A, B = to 19 stitches
- 5 -
!0
9
C, D = 5 to 500 stitches
Hide quick links:
Advertisement
Table of Contents
