Jeep Compass 2021 Owner's Manual page 16

14 GETTING TO KNOW YOUR VEHICLE
All doors can be programmed to unlock on the
first push of the unlock button within Uconnect
Settings Ú page 139.
Replacing The Battery In The Key Fob
The replacement battery is one CR2032
battery.
NOTE:
Customers are recommended to use a

battery obtained from Mopar. Aftermarket
coin battery dimensions may not meet the
original OEM coin battery dimensions.
Perchlorate Material — special handling may

apply. See www.dtsc.ca.gov/hazard-
ouswaste/perchlorate for further informa-
tion.
Do not touch the battery terminals that are

on the back housing or the printed circuit
board.
Key Fob:
1. Remove the emergency key (2) by sliding
the emergency key release (1) on the back
of the key fob and pull the emergency key
out with your other hand.
Emergency Key Removal
1 — Emergency Key Release Button
2 — Emergency Key
2. Separate the key fob halves using a #2 flat
blade screwdriver or a coin, and gently pry
the two halves of the key fob apart. Make
sure not to damage the seal during removal.
Separating Case With A Coin
Key Fob Battery Replacement
3. Remove the back cover to access and
replace the battery. When replacing the
battery, match the (+) sign on the battery to
the (+) sign on the inside of the battery clip,
located on the back cover. Avoid touching
the new battery with your fingers. Skin oils