White Indicator Lights; Blue Indicator Lights - Jeep Compass 2021 Owner's Manual

NOTE:
A continuous chime will sound if the vehicle is

driven more than 1 mile (1.6 km) with either
turn signal on.
Check for an inoperative outside light bulb if

either indicator flashes at a rapid rate.
W I L
HITE NDICATOR IGHTS
Hill Descent Control (HDC) Indicator Light
— If Equipped
This indicator shows when the HDC
feature is turned on. The lamp will be
on solid when HDC is armed. HDC can
only be armed when the transfer case
is in the 4WD Low position and the vehicle
speed is less then 30 mph (48 km/h). If these
conditions are not met while attempting to use
the HDC feature, the HDC indicator light will
flash on/off.
Idle Coasting — If Equipped
The Idle Coasting feature saves fuel
by allowing engine speeds to drop to
idle. When Idle Coasting is active, the
Idle Coasting Indicator Light is shown
in the Instrument Cluster Display.
LaneSense Indicator Light — If Equipped
When the LaneSense system is ON,
but not armed, the LaneSense
indicator light illuminates solid white.
This occurs when only left, right, or
neither lane line has been detected. If a single
lane line is detected, the system is ready to
provide only visual warnings if an unintentional
lane departure occurs on the detected lane line
Ú page 120.
Cruise Control Ready Indicator Light — If
Equipped With A Premium Instrument
Cluster
This light will turn on when the Cruise
Control has been turned on, but not
set Ú page 104.
Cruise Control SET Indicator Light — If
Equipped With Base Instrument Cluster
This indicator light will illuminate
when the Cruise Control is set
Ú page 104.
GETTING TO KNOW YOUR INSTRUMENT PANEL
Speed Warning Indicator Light — If
Equipped
When Set Speed Warning is turned on
and when the set speed is exceeded,
a single chime will sound along with a
pop-up message of "Speed Warning
Exceeded." Speed Warning can be turned on
and off in the instrument cluster display.
The number "55" is only an example of a speed
that can be set.
B I L
LUE NDICATOR IGHTS
High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams. Pull the multifunction
lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are
off, pull the lever toward you for a temporary
high beam on, "flash to pass" scenario.
83
3