Fuel Tank - Husqvarna 522HD60X Workshop Manual

7.14 Fuel tank

7.14.1 To do a tank venting
1. Drain the fuel tank and turn the product with the top
down.
2. Remove the transparent fuel hose from the
carburetor and connect it to the pressure tester.
3. Tighten the fuel tank cap. Make sure that the are no
leaks around the bushings in the fuel tank.
4. Use the pressure tester to make a negative pressure
in the tank. If there is no pressure or the negative
pressure is very low, replace the fuel tank.
7.14.2 To remove the fuel tank
1. Drain the fuel tank and put the product on its side.
2. Remove the transparent fuel hose from the
carburetor.
1012 - 002 -
3. Remove the 2 screws and remove the handle cover.
4. Remove the fuel tank.
5. Use pliers to open the clamp and remove the fuel
hose from the fuel tank.
Repair instructions - 51