Husqvarna 522HD60X Workshop Manual page 22

7. Remove the locking washer (A) with a screwdriver.
This causes deformation of the washer. Discard the
washer.
C
B
A
8. Remove the starter pawls (C) and springs (B).
7.6.2 To clean and examine the flywheel
• Examine the flywheel for cracks and damage.
• Make sure that the key in the flywheel and keyway
are not damaged.
• Clean the crankshaft from grease and oil.
22 - Repair instructions
7.6.3 To assemble the flywheel
1. Make sure that the key in the flywheel and keyway in
the crankshaft are not damaged.
2. Attach the recoil spring (B) and the starter pawls (C)
on the flywheel.
Note: Make sure that the recoil spring is attached to
the flywheel.
3. Attach new locking washers.
CAUTION: Always use new locking
washers.
C
B
A
1012 - 002 -