Arm Assembly - Weider WESY19541 User Manual

8. Attach the Shroud (17) to the Top Frame (4) with
two M6 x 16mm Screws (62) and two M6
Washers (82). Do not tighten the Screws yet.
Attach the Shroud (17) to the brackets on the
Stabilizer (2) with two M6 x 16mm Screws (62)
and two M6 Washers (82). Make sure the brack-
ets are inside the Shroud. Tighten the four
Screws used in this step.
Tighten the Nylon Locknuts (56, 58) used in
steps 2–7.

Arm Assembly

9. Grease the M10 x 77mm Bolt (79). Orient the Leg
Lever (8) with the welded support on the side
shown. Attach the Leg Lever to the Front Leg (7)
with the Bolt and an M10 Nylon Locknut (56). Do
not overtighten the Locknut; the Leg Lever
must be able to pivot easily.
10. Grease the M10 x 77mm Bolt (79). Attach the
Pivot Frame (5) to the Top Frame (4) with the Bolt
and an M10 Nylon Locknut (56). Do not over-
tighten the Locknut; the Pivot Frame must be
able to pivot easily.
Attach the two Arm Pins (40) to the Pivot Frame
(5) with two M4 x 20mm Self-tapping Screws
(69). Insert the Arm Pins into the two holes in the
Upright (3).
8
82
62
62
82
9
8
Welded
Support
10
56
5
69
40
9
4
17
2
Bracket
82
62
56
7
Grease
79
4
Holes
79
3
Grease
69
40